![]() ![]() If it has not been assigned an IP address, you can try the fallback: 192.168.1.30. Note: The IP address comes from your DHCP server.Open your browser and type the IP address for the Cloud Key.Continue holding the Reset button for 10 seconds, until the LED flashes blue and white.Press and hold the Reset button and then connect it to the power source.The firmware will upgrade and the device will automatically reboot once it has finished. Once in TFTP, paste the following commands and hit enter.Enter TFTP mode by entering the command:.Select the downloaded firmware image and transfer it to the AP.Use the built-in TFTP command line tool, or a separate program such as Tftpd64 or pumpKIN.There are various programs and methods for accomplishing this. ![]() Use TFTP to move the firmware from your computer to your AP.The following is an example configuration: Set a static IP address on your computer to communicate with the AP, which has a default IP address of 192.168.1.20.This indicates your device is ready for TFTP Recovery and you can release the button. Continue holding the Reset button until the LED flashes white, blue, off as indicated in our LED Status Guide.Press and hold the Reset button, and connect your computer to the available ethernet port of the AP.Connect your AP and computer to the same network or VLAN, either through a PoE switch or by connecting the computer directly to the network (data) port on the PoE adapter.Download the most recent firmware for your device, found here. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |